Here you go Ted:
-Mix gasoline with 2-stroke oil in approved container. Use mix ratio recomended by the oil manufacturer.
-Pour gasoline/oil mix into fuel tank. Don't smoke while doing this.
-Pour bar/chain oil into bar oil tank.
-Set choke.
-Set off/on switch to "on".
-Set throttle lock.
-Orient saw so that sharp end is away from you.
-Put one hand on wrap handle.
-Grab starter handle with other hand.
-Pull starter rope. Repeat as needed.
-Once saw 'pops', set choke to 1/2 (or fully open if ambiant air is 'warm') and pull rope again. Don't touch sharp part of saw while doing this.
-Once saw starts, place left hand on wrap handle and right hand on rear handle.
-Pull throttle trigger and place sharp end of saw on wood that you wish to cut. Repeat as needed.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Or do you need it in Swedish?
Good morning, gents ...
Anyone have an operator's guide for a Partner S50?
TIA!
