MarkEagleUSA
ArboristSite Guru
I picked up a Fast Tach this week based on comments and recommendations here on AS. Used it a bit this weekend to tune my 162SE and had some issues with it.
Trying to hold it with my left hand on the saw with the arrow pointing at the plug, it will randomly go crazy where the entire LCD turns on and it stops counting RPM's. It's almost like it's resetting itself. After a couple of seconds, the display will return to "0000" and it will begin counting RPM's again. It will do this occasionally when held in other positions as well. I even went out yesterday and bought a new battery thinking that might be the problem but it's still doing it.
I've sent an email off to Design Technology but was wondering if anyone here has experienced similar issues?
Trying to hold it with my left hand on the saw with the arrow pointing at the plug, it will randomly go crazy where the entire LCD turns on and it stops counting RPM's. It's almost like it's resetting itself. After a couple of seconds, the display will return to "0000" and it will begin counting RPM's again. It will do this occasionally when held in other positions as well. I even went out yesterday and bought a new battery thinking that might be the problem but it's still doing it.
I've sent an email off to Design Technology but was wondering if anyone here has experienced similar issues?