Stihl ms250 wiring help

[brad ruch]

Anyone have a pic of where the wires go?I'm building a Chinese nock off.lol

Sent from my Pixel 2 XL using Tapatalk

 

[HarleyT]

The 2 spade terminals go up to the throttle control, the others go to the coil.

 

[HarleyT]

One of the spade terminals clip onto the spade on the copperish spring, the other one slides in the slot on the throttle control, and touches the copperish spring when the control is flipped to the off position.

 

[brad ruch]

There's also a ground screw on the side of the cylinder.

Sent from my Pixel 2 XL using Tapatalk

 

[HarleyT]

On the other end, the spade clips onto the spade on the coil, the ring terminal goes to ground.

 

[brad ruch]

I think I got ya.ill take a pic later

Sent from my Pixel 2 XL using Tapatalk

 

[HarleyT]

Here.

 

[brad ruch]

Thank you sir!!!

Sent from my Pixel 2 XL using Tapatalk

 

[brad ruch]

Looks like only 2 wires?one from side of cylinder which is ground to the metal strip.and from coil connector up to the flip switch.they sent like 3 or 4 wires.no wonder i was confused.lol

Sent from my Pixel 2 XL using Tapatalk

 

[brad ruch]

Spade wire on coil to switch,wire on metal tab to ground on coil,short black wire on ground coil to side of cylinder.

Sent from my Pixel 2 XL using Tapatalk

 

[HarleyT]

Run a jumper from the coil mount to the block.

 

[brad ruch]

Yup there is you just can't really see it on the coil.bith wires are on the bottom screw

Sent from my Pixel 2 XL using Tapatalk

 

[brad ruch]

Theses things are junk.nothing really lines up perfect.

Sent from my Pixel 2 XL using Tapatalk

 

[brad ruch]

Well it runs.actually runs quit well surprised.

Sent from my Pixel 2 XL using Tapatalk

 

[chipper1]

Nice work Brad.
Building anything else lately.

 

[brad ruch]

Lol these things are not fun at all.ill pass on another.havent did anything else lately.

Sent from my Pixel 2 XL using Tapatalk