Ekka
Addicted to ArboristSite
What you do not get is the descent is already on the machine. Just as in the Swiss machine you mention. Don't you get it?????
You can zip up above a dead limb with the machine and you need no transfer whatsoever. You just rapel off of the tie in on the machine. You can essentially reverse your progress at any time leaving the machine behind (in mid air even). You have to put on a figure 8 or descender of some kind and change over.
Here we go again, I think you just cant comprehend. Even in Jerry's video we see him with a Drt system hanging off the device. But that is NOT THE SAME as reversing the motor or direction to come down is it (as per the Swiss electric)? For instance, you Drt down 30' but decide you need to go back up, the machine is 30' above you, you'll have to hump it up.
This is what I wrote:-
Lordy, here I'll help you.
So, does the Wraptor ascend 1 piece of rope, like does only 1 piece of rope go in the spool? If that's the case then it's the same, it is a single line ascender and how you manipulate to get DRT will be the same for other machines.
The only one that is truly different is the Swiss electric version as that does go in reverse, so you can ascend, flick a reverse switch on the electric motor and it will descend ... no gadgets or gear required.
The petrol model like a car cannot run the engine in reverse, to run the drive in reverse you need (like a car) a reverse gear, which I doubt the Wraptor has.
And you have dodged the issue. Here's my posts regarding it.
Lordy, and he's at it again. What did I just write? Your logic is like saying a different descent method has to be used depending on the saddle you are wearing, sheesh mate, get some help!
As you can all see (except Treevet) there's many ways and none are unique to either machine.
With the method I use the machine is always within reach, right where I am working, I need to go up and it's throttle away, need to come down I just slide my prussic ... have you figured that out yet?
Now regarding this rubbish:- My comments will be in red here because you are way off track.
The subject was cabling and you trying force feed the rubber band cabling system on a knowing audience and was made to look silly from lack of experience and knowledge.
What force feeding, I posted a picture of a fall arrest system, you slammed that system until you found out it was Sean Freeman's job, then you did a backflip, sucked up Sean's butt and even then boasted how you install those, but not long after did another backflip.
I was right as well about your arrogant behavior and know it all attitude that had led to the banning of most of your high level members on your own forum by dictator you
They get banned for a reason, and the common denominator is the low life conduct, such as you are displaying here, name calling, belligerence, inaccuracies, lies etc. There's more to be assessed than a persons qualifications, no matter who you are. The place is booming, has outstripped Dunlap's boghole, left TH in the dust and shown the Poms how little they know, it appears people actually enjoy not having the types of brawls there that happen like in this thread.
We know each other much better than you would lead one to believe, don't we.
And this is why you cannot be trusted, because you backflip all over town and what was held in confidence by you will be blurted out for your own perceived personal gains. You are volatile and untrustworthy, even in the face of adversity and what you do I keep my secret, what was said or written I keep in confidence ... but you aren't of that caliber hence why you were booted out of the Confidential forum. You are not banned though, I'm bigger than that, with you I just have to present the facts and the readers can see you for what you are.
Your behaviour and carry on in this thread a perfect example.
I can see why you have been reading books for 40 years and have no clue as to what you have read.... comprehension issues.
Last edited: