Any advice on changing out cutter wheel on carlton 4012/5014 ?

[jaystihl]

Hey guys i am going to change out the cutter wheel on my carlton 5014. cant find any instructions in the manual, so i was hoping someone here could lead me in the right direction. I have heard the bearings are a pain and will have to be pressed off the cutter shaft. im pretty sure its the same setup as the 4012 which has been out for quite a while. Any tips greatly appreciated.

 

[Brian Holly]

Hello Jason, I have instructions for a 4012 which should be identical to the 5014.

 

[howel07264]

Hey guys i am going to change out the cutter wheel on my carlton 5014. cant find any instructions in the manual, so i was hoping someone here could lead me in the right direction. I have heard the bearings are a pain and will have to be pressed off the cutter shaft. im pretty sure its the same setup as the 4012 which has been out for quite a while. Any tips greatly appreciated.

You might want to look into the Alpine Rhino wheel. I have a buddy that swears by them especially on low HP gas grinders.