bar squeezing a .063 duromatic bar to .050

[chunez]

With the lack of long .050 bar options, I had the bright (dumb?) idea to use a bar closer on a 47" .063 stihl duromatic bar to get it down to .050. This would allow me to use 3/8LP, .325 and 3/8std for milling chain experiments. I know the solid nose bar will have more drag and I will have to run a slacker chain, but would that work? I've read the tip (or whole bar?) on these is super tough stellite, think the squeezer would work on this?

 

[singinwoodwackr]

Good luck. I got one, tried it, failed miserably and went back to my old method using my vise.
Be advised…doing this is a short-lived deal. You will have to true the rails after pinching and, the rails will wear down, eventually to the point you cannot repeat.
If you do not have the right tool to get the rails perfectly trued…1/2 a degree off will get you cutting crooked…don’t even bother.

 

[J D]

It won't work, you can't close the rails up evenly because there is solid metal at the base of the groove... so you will just get a taper that will retain the narrower chain slightly better but still allow a significant amount of movement & greater wear on the bar as a result of less surface area contact.
Why not just buy all your chai s in 063... they're generally available.