Carb adjustment for easier starting?

[david newbie]

Some saws seem to take a lot of pulling, even after a carb rebuild. Is there any sort of general rule of thumb? I can usually adjust the low speed screw okay while it’s running, but I always wonder if a little leaner or richer would help it start easier. Asking this question while I’m working on a very low hour sexy Wild Thing I know there’s going to be a dumpster comment. I paid 80 total for the 3 saws

 

[oldguy]

I like to think a little richer on the low screw works best, then bring the idle screw up to get a clean idle, this for cold starting.