Chainsaw help

[Woody912]

Check the intake boot for crack's it's very common for those to fail on that series. Had 2 of the 360's and both failed for that reason. When I finally found new boots the ignition modules had apparently gone bad.

 

[Nathan Bruce]

I chekced th eintake boot today and felt it, there were no cracks. I lowered the metering lever a little bit and got the saw to run for a little then it died, I think that i flooded it again I will try again tomorrow.

 

[Nathan Bruce]

thanks for the advice everyone!

 

[PV Hiker]

While your checking things... check the exhaust screen that it not plugged up. Often over looked.

Pinched fuel line?

 

[Nathan Bruce]

While your checking things... check the exhaust screen that it not plugged up. Often over looked.

Pinched fuel line?

I just replaced the line a week or so ago and appear to be getting good flow. When I first got the saw a month ago I cleaned up the muffler some.