Crank Shaft Oil Seal Puller

[Vintage Engine Repairs]

Working on an 066, I’ve used this puller a lot, so it’s paid for itself by now and it’s great, but not cheap.

 

[Vintage Engine Repairs]

I made a seal sleeve for the step too.

 

[altatim]

Where did you happen to purchase the puller from? Thanks

 

[Vintage Engine Repairs]

My local stihl dealer

 

[chainsaw-57]

Suggestion.

Remove wing bolts and install T-27 5mm Torx screws. You can push the wings out harder.

Suggested to me from the top STIHL Tech.

Larry. HOS

 

[president]

My local stihl dealer

how much $ Tom?

 

[altatim]

I found the tool, you can get it for $150 from sawpartscanada. Definitely an investment but Ill probably be getting one myself. Ill have to see if it works with dirtbikes because I do lots of that work too

 

[Vintage Engine Repairs]

how much $ Tom?

In the US it’s probably cheaper, but it was $350 AUD or there abouts in 2019.

 

[SteveSr]

In the US it’s probably cheaper, but it was $350 AUD or there abouts in 2019.

BTW, the best way to use this tool is to gently tap the seal in a bit all way round to loosen it up before trying to pull it out.

 

[Vintage Engine Repairs]

Absolutely right, the manual even recommends it too.