what's wrong with this picture! Husqvarna 353 crank seals

[david newbie]

This saw came to me as 2 torn down 353s in a box. I managed to get one of them working well. This one came to me without a seal on the PTO side. I ordered some 353 seals on ebay (aftermarket) but they seem wrong. It will fit snugly( think) around the crankshaft but there's a big gap at the outer race of the bearing? Are my seals wrong or is something strange about that bearing. Thoughts?

 

[Chevboy0167]

Bearing cage looks like it left the chat..... Replace both bearings.

 

[Chevboy0167]

PTO or clutch side is a radial seal. Need year and /or serial number for correct seal.

 

[Chevboy0167]

Ohhhhhhhhhh... just noticed...... half the bearing pocket looks gone!

You will need to find a right-hand crankcase half. The crankshaft will most likely never stay in place.

Yikes... look like I need a distraction. Ladies and gentleman, Mr. Conway Twitty...

 

[Bob Hedgecutter]

For future reference- you tend not to put new oil seals on top of bearings where the balls of said bearing are no longer evenly spaced- and that is before even mentioning the buggered up case bearing pocket.

 

[david newbie]

I guess that’s why it was in a box. Whoops

For future reference- you tend not to pit new oil seals on top of bearings where the balls of said bearing are no longer evenly spaced- and that is before even mentioning the buggered up case bearing pocket.

I thought it looked a little funny