David Bradley restoration

[Zipster]

Hey i need a little bit of info on the ah58 power product 95 cc motor , l took the top of cylinder off , i guess you could call it the head , no gasket. My guess is it does not need one , just trying to find out for sure i can't find a IPL on it thanks in advance for any help, this site is a lot of help .

 

[camel2019]

Idk if my eatons has one or not but it has a ah58 on it if you don’t get an answer I will pull my head and take a look.

 

[Zipster]

Idk if my eatons has one or not but it has a ah58 on it if you don’t get an answer I will pull my head and take a look.

 

[Zipster]

I found a old parts diagram on the ah58 , it looks like it does'nt use a gasket. Thanks . Now i have another problem the needel bearings are shot , i believe the crank is ok the rod end is showing a small amount of scoring might be able to clean it up if i can't find one. Does anyone know where i can find some , it uses 28 on on a single row. I did find a part number on them it is 530126 , thanks in advance.

 

[64poncho]

I found parts for my AH81 on Vintage Karting Association site, a few years back. They used these engines on go karts. I copied the info from the current site.
Contact Bobby Muha.

Bobby Muha has power products parts 58, 61, 81 and 82.-pistons, rings, seals, bearings, new cylinders, gaskets and engine rebuilding. contact [email protected]
phone 601.317-2249

 

[camel2019]

I found parts for my AH81 on Vintage Karting Association site, a few years back. They used these engines on go karts. I copied the info from the current site.
Contact Bobby Muha.

Bobby Muha has power products parts 58, 61, 81 and 82.-pistons, rings, seals, bearings, new cylinders, gaskets and engine rebuilding. contact [email protected]
phone 601.317-2249

Think mine needs new rings but I might just source some that are the right size. There used to be a website that had all kinds of parts for these engine mainly as kart engines. Wish I could find a clutch for the Eatons for .404 or 3/8 chain it would be fun to drag out and have some fun with once and a while but I don’t want to wreck the almost new loop of 7/16 chain.

 

[Zipster]

Thanks

I found parts for my AH81 on Vintage Karting Association site, a few years back. They used these engines on go karts. I copied the info from the current site.
Contact Bobby Muha.

Bobby Muha has power products parts 58, 61, 81 and 82.-pistons, rings, seals, bearings, new cylinders, gaskets and engine rebuilding. contact [email protected]
phone 601.317-2249

Think mine needs new rings but I might just source some that are the right size. There used to be a website that had all kinds of parts for these engine mainly as kart engines. Wish I could find a clutch for the Eatons for .404 or 3/8 chain it would be fun to drag out and have some fun with once and a while but I don’t want to wreck the almost new loop of 7/16 chain.

Thanks saving that info for sure

 

[Zipster]

Hay i got to check the crankshaft seals today, both sides are leaking . My question is how to remove the seals its the ah58 power products motor ,its the one that has the keeper ring . I have never done one of these . l have tried getting a pick behind the ring no luck. Just wondering if you have to split the crankcase any help would be greatly appreciated. Thanks in advance.

 

[camel2019]

Never dove that far into mine I probably should at some point.