Homelite Chainsaws

[xl130]

Got the bar and chain sorted

 

[Piotr Pakuła]

Is the SXL-925 piston available?

 

[cbfarmall]

Only aftermarket unless you get lucky. I'd check that cylinder first. That's one hell of a gouge over the ring.

 

[Piotr Pakuła]

Yes, you are right, first I need to look at the cylinder, I found an Lrb piston or I can try to convert the piston to thicker rings. Then I would buy 52.5mm metric rings

 

[Piotr Pakuła]

Is this 2 part filter correct? Is this some kind of modification

 

[Piotr Pakuła]

Someone must have modified the chain tensioner

 

[moxiemaul]

Bar adjust looks the same as on my SuperXL Auto. What part are you thinking is modified?

 

[Piotr Pakuła]

Bar adjust looks the same as on my SuperXL Auto. What part are you thinking is modified?

The guide I received is a converted Chinese 24"

 

[Piotr Pakuła]

Piston sxl-925 / 32€ / Closer to me
https://agroparts.gr/p/piston-kit-for-homelite-super-xl-925-52-38mm/

 

[Piotr Pakuła]

Is this 2 part filter correct? Is this some kind of modification

I suspect that it is an additional pre-filter that also seals the outer edge. Thanks to this, the filter is as good as new

 

[cbfarmall]

Is this 2 part filter correct? Is this some kind of modification

More like 2 different filters stacked one on the other--OEM and aftermarket. Never seen 2 flat filters stacked like that on any saw.

 

[Piotr Pakuła]

More like 2 different filters stacked one on the other--OEM and aftermarket. Never seen 2 flat filters stacked like that on any saw.

The black one is clogged

 

[Yukon Stihl]

A 26 LCS question
I got a seal for the flywheel side that was leaking and installed it.
Then I pressure tested again and found a hole in the crankcase that leaked under pressure. It is on the edge close to the belt case.
Is this a case where it’s supposed to be open ? The parts saw I have has a casting mark but no hole
Thanks