Want to Buy Dolmar or Makita Saw: 6100, 6300, 6400, 7300, 7900

[bigv]

I am looking for one of the saws above.


Would prefer a Dolmar Orange Top in an of the above sizes. However as they are just colors, a Dolmar Blacktop is fine as is a Makita.

Essentially what I am looking for is a good farm and work saw. My go to for dirty deeds done dirt cheap was my Husqvarna 365 Special which was stolen once and recovered, I didn't get it back until the trial of the thief was over and the when it was recovered the throttle lockout was fine as was the electrical kill switch. When I finally got it back from the evidence locker the saw looked like a crash test dummy- throttle lockout completely gone and the electric kill switch was missing. and the chainbrake plastic was gone. Had another break-in while I was at work and the idiots took two miter saws, a concrete mixer and they got my 575XP and the 365. New sheriff, he returned them immediately. However the 575XP has not been right since and though I love the 365 Special, the only kill is the choke. I still have to figure out all the throttle lockout pieces to order, anything to go back to an electric kill, and get a chain brake. I also need to replace all the filters and lines.

For right now, I am looking for a Dolmar or Makita. Any model listed up above. If it comes with a good bar, good chain- great, if it is only the power head that's liveable too.

I can pay Zelle, Paypal F/F, CashApp, or mail a USPS Money order.

Please send me a personal message with what you have, what you want for it shipped to residence in Murphy NC 28906.

Thank you all.

 

[Edwad]

Pm sent

 

[bigv]

Looking for a 6300, 6400, 7100, 7300, 7900 in the $475 range shipped. Prefer Dolmar branded but truth be known I am fine with Blue or Orange Makita saws.

I had purchased a 372XP someone set for 100LL oxygenated fuel for planes. It appears it has sold and will cease to cause me problems and I hope the new owner likes it. I am putting the money into a bigger Dolmar. If it comes with a cheap 20"-24" bar that is ideal.

 

[Lightning Performance]

Looking for a 6300, 6400, 7100, 7300, 7900 in the $475 range shipped. Prefer Dolmar branded but truth be known I am fine with Blue or Orange Makita saws.

I had purchased a 372XP someone set for 100LL oxygenated fuel for planes. It appears it has sold and will cease to cause me problems and I hope the new owner likes it. I am putting the money into a bigger Dolmar. If it comes with a cheap 20"-24" bar that is ideal.

Cheap and 64xx-79xx does not compute. You're looking at 650.

 

[paul guthrie]

Hi... I have a Sachs-Dolmar 133 Super if you are interested.....

 

[SawPonder]

I've got a makita 6421 that's been completely disassembled, cleaned, inspected, new crank seals, and fuel filter, base gasket deleted. All OEM parts used. Fires first or second pull every time. Idles well, oils good, chain brake works.

Only things it needs is the short wire needs the connector at one end repairs. New piston rings wouldnt hurt, i did not change them. Fuel vent was plugged so I put a tiny hold in it so it'd run, so it'll need a new one, drips fuels if turned upside down

It's on ebay for 600 Shipped or maybe a bit less if we dont go through ebay (I live like 4 hours from murphy, so shipping would be quick. Saw is work ready and the crankcase and card have passed pressure and vacuum tests.