Dolmar ps401 OR stihl 192 rear-handle?

[Lakeside53]

That as the runner-up on my shortlist, but it didn't feel like it would handle as well, and it has a smaller engine.

+ I wanted something that not "everyone" has, this time.....:greenchainsaw: :rockn: :rockn:

You'll never know unless yoo run one... and very few have them, even over here..

BTW, it handles GREAT...

 

[zemmo]

I bought a PS401 with 14" b/c a couple months ago and really like it. My only gripes are:
The chain oiler flow is set a tad too high. It always runs out of chain oil before gas.
On mine, the drive sprocket spurs were uneven. Replace it with a GB part, it's much better.
Other than that, it's a great little saw.

I got a 411, but didn't run it that much as the cutting season (for me) was nearly over. The overoiling problem was kinda bad (13" bar) with Bailey's bio bar oil, not as much with motion lotion. I like the saw quite a bit, once I got the carb tuned in.

 

[SawTroll]

I believe it would handle it. I have put it through the paces and it has not let me down or dissapointed me. I really like the saw.

You'll never know unless yoo run one... and very few have them, even over here..

BTW, it handles GREAT...

I believe you both, but I like the feel of the 339xp better - the handle spacing is probably the main reason.

It sure is a cool little "toy" to use! :rockn: :rockn: