Echo CS-3510 carburetor settings

[Rooster Coggburn]

Hello everyone, I'm trying to get my Echo CS3510 dialed in. It won't stay running now that it's cold out. If I let it idle for a bit when I grab it to use it it does. I figured that the low setting is to lean so I removed limiter caps so I can get it dialed in. Now it feels like I'm chasing my tail. Does anyone know what the initial settings are for low and high so I can start over. Thanks

 

[irhunter]

I imagine the shop manual has what you're looking for.

Ask for one here, if you don't have it:

https://www.arboristsite.com/threads/the-beg-for-manuals-thread.68615/page-1803#post-7906565
For the future...right after removing the limiters, I write down the carb settings before adjusting them.

Roy

 

[esean]

If its dying after a long idle the L could be too rich. Other smaller Echo saws all have similar factory L settings of about 1.5 turns out, but the H settings range from 1.5-3.5 turns out.

 

[Rooster Coggburn]

I imagine the shop manual has what you're looking for.

Ask for one here, if you don't have it:

https://www.arboristsite.com/threads/the-beg-for-manuals-thread.68615/page-1803#post-7906565
For the future...right after removing the limiters, I write down the carb settings before adjusting them.

Roy

Thank you, I ended up getting it dialed in. It was way further out than I expected. I started at 1-1/2 out on low, ended up at 2-5/8! High was 3-1/2.