Ertreesurgeon
ArboristSite Member
hi there. i was wondering if someone might be able to have some ideas for me. my lower feed wheel on my chipper stopped working yesterday. i pulled the roller stator off thinking that was the problem. it wasn't but it did reveal the problem. the stator has a shaft with about 8 little ridges on it. theses were ok, but the receiving end of the feed wheel where the shaft slides into, these opposite ridges are worn out. i was wondering if i need to replace the whole feed wheel or can i get a new piece welded in. has anybody else ever had this problem. the chipper is about a 98..
