help with husqy 350 tear down

[oaktree]

Any help with a link to video tear down of husqy 350 . Mainly carb and boot removal . Saw of 5 or 6 years and many cords of wood started to run lean , it would not adjust richer . I'm looking into the boot first , then I'll check lines,and fuel filter . Any Ideas what else it could be . Where is and how to check tank vent if that could be it .

thanks already rt

 

[moody]

http://www.arboristsite.com/chainsaw/237587.htm

This thread is a good place to read. You can't richen the tune you've got an air leak. Most likely a plastic boot clamp failure. This will have lots of answers for you there.

 

[nmurph]

Remove the top cover.
Remove the filter.
Remove fuel and vent line.
Remove the two carb bolts from rear.
Remove carb from isolation mounts.
Lift carb out.
Remove the muffler and bracket.
Remove the four cylinder bolts.
Pull the cylinder off piston (but not before checking squish).
Remove intake.

Reverse for reassembly (and delete base gasket if possible, using liquid gasket for sealant).

 

[mweba]

Not exactly what you are looking for but this is how I do them. Will no longer send one out without the riser resealed.

[video=youtube_share;gap4qZC6fKg]http://youtu.be/gap4qZC6fKg[/video]

 

[oaktree]

re

thanks everyone ! good info rt