Homelite 360 carb

[Mike mandry]

Hey guys, Im finishing up a like new Homelite 360 (sears branded) & I must have misplaced the carb somewhere.

Ive been looking for a week now & have about turnrd the place upside down.

Anyone have a good used rebuildabe carb ?? Its a "Newer" model 360 with the Walbro HDC carb.

If ya got one let me know how much you need for it. Ive also got a ton of stuff I can trade if interested.

Thanks

Mike

 

[galde]

Mike: I looked at my stock of Walbro HDC carbs (nine new ones, all differing in some details). I found one that closely matched the HDC in one of my Homelite 360 saws. The throttle arm on the saw's carb points upward and is mounted on an extension of about 1/2 inch length beyond the part that bumps against the idle adjusting screw. The throttle link on the saw moves rearward when the trigger is pulled. The arm on my spare carb points downward and is integral with the idle bumper arm. It is pushed forward to open the throttle. Also the idle adjusting screw on the spare carb might be of a smaller diameter than the one on my saw, so it might not fit snugly in the rubber boot. If you think you can use this, email me your mailing address. I would rather trade for like-value parts (or junk) than sell.

Darrell Galde

 

[Mike mandry]

Here is a picture of the sears branded 360 that I need the carb for & one of my other 360's carb.

I'm going to look at work tomorrow for the lost carb. It might be there, as I did bring it in to wash it in the solvent tank.

Thanks for the help & i will keep you posted.

Mike

 

[chainsawworld]

the Homelite 360 calls for a Walbro HDC-39. marty

 

[Mike mandry]

Thanks for the help guys. But.......I found it at work today (duh) just where i left it months ago.

Mike

 

[oldwild]

that sears/homelite doesn't even look like my 360! Especially the carb, and I know the carb on mine is an HDC!