Husky 570 bearing

[Jasonrkba]

Im feeling a little challenged today maybe it's the weather. I need a replacement for the flywheel side and the IPL I am using doesn't seem completely clear. Seems its part number 505 41 60-01. Here is the one I pulled. Is the part number Im using correct?.

 

[rob066]

What year saw? That is the clutch side bearing with the radial seal

 

[Jasonrkba]

Sorry about that I'm all over the place today.

 

[rob066]

flywheel side bearing

738220225​

 

[Jasonrkba]

And 6202 c3 for the other side correct?

 

[rob066]

And 6202 c3 for the other side correct?

738220225 is for the flywheel side the other bearing you have in the photo is for the output/ clutch side

 

[Jasonrkba]

I must have mixed them after they where pulled. The one in the photo is the one I need.

 

[thenne1713]

Im feeling a little challenged today maybe it's the weather. I need a replacement for the flywheel side and the IPL I am using doesn't seem completely clear. Seems its part number 505 41 60-01. Here is the one I pulled. Is the part number Im using correct?.

About 40-yrs out of practice, but 6001 stamped on race anywhere? Suspect The other digits define the seals? E.g. This might work? Double sealed (gas/oil resistant seals) probably better, but (???) (Not familiar w/ PGN bearings, suspect Chinese vs German/ British/ USA?) IN the LINK, the "2RS" means "Two rubber shields" in the olden days. https://pgnbearings.com/products/60...c4e7eef7c147a39549c&utm_term=4585925563324479

 

[Jasonrkba]

The bearing was made for husqvarna by skf. The seal is much thicker than a typical rubber bearing seal.