Husqvarna 350 bearings

[Jasonrkba]

If I measured correctly they are just 6202 bearings. Is this correct?

 

[Jasonrkba]

35x15x11 Gotta be 6202.

 

[J D]

Correct.

If you buy generic bearings you still need to press the seal on to them which can be a PITA... & Getting the seals back off a bearing without damaging anything is damned near impossible in my experience

 

[Chevboy0167]

I have been getting these and using a bearing/seal driver kit to install the seals on the bearings. Working great so far....

https://www.ebay.com/itm/143898585488
https://www.ebay.com/itm/2036245501...w9jm5Ub33O0RWOVu7pSUO7SVw=|tkp:Bk9SR8S1yJvBYA

 

[Jasonrkba]

Yea... I do not like this type of seal. It makes buying parts in bulk more complicated.

 

[Chevboy0167]

Yeppers. Funny part is, the little 136/141 series Huskys are the same setup and they come with the seals already installed on the bearings.

 

[Jasonrkba]

I did one of those 136's a few years ago with aftermarket and I remember there was a good amount of bad language involved.

 

[Chevboy0167]

They not so bad when ya get like 8 or 10 under yer belt! LOL The 300 series just seem like a bigger brother variant after I did my first. Most of my "sophisticated" language got said when I did my first and 2nd and 3rd Stihl brand pieces of equipment. Kinda like this TS 420 concrete saw I have torn all to hell now just to get the carb off for a rebuild.... sheesh!

 

[Tomos770]

35x15x11 Gotta be 6202.

Buy them in C3 variant/tolerance!

6202 C3

 

[Jasonrkba]

Nachi C3 is my usual go to. SKF, KOYO and Timken are equally good.

 

[Chevboy0167]

Just tonight!