Want to Sell Husqvarna 372xp, 20" bar and chain, $375

[epicklein22]

Up for sale is a good running 2003 Husqvarna 372xp chainsaw. Starts and runs well. New OEM crank seals, fuel line, fuel filter, gas & oil caps and rim sprocket. In decent shape overall, just the normal scrapes and scratches from use. Muffler is dented, but doesn't leak or effect performance. There is a crack in the clutch cover up top, but I'm gonna drill the end of it and give it a layer of JB Weld. Comes equipped with a 20" bar and chain. Overall, this saw is in good shape and ready for work. $375

PM is probably the best way to reach me, or you can call, Andrew 330-281-0069.

 

[epicklein22]

I forgot to snag a picture of the muffler or crack. Will have some later today hopefully. Also, I do have aftermarket, tube style 372 mufflers if someone would like it swapped out.

 

[04titanse]

message sent.

 

[epicklein22]

Piston picture, which shows it in good condition. I also did a compression test. It came in a 135. That's a lot lower than I expected, so I'm going to install a set of rings, check the piston clearance (replace if needed) and put it back up for sale at a later date.

 

[komatsuvarna]

Depending on your elevation, that may not actually be that low, Andrew. I bought a new 372 in 09, it didn't pull but 140 fully broken in.

 

[nmurph]

Depending on your elevation, that may not actually be that low, Andrew. I bought a new 372 in 09, it didn't pull but 140 fully broken in.

Yep...how much machining is still visible?

 

[Tractorsaw1]

Seen a lot of 372's & 2171 with a 135 gauge showing. Figured its a husky thing?

 

[RedneckChainsawRepair]

135psi not bad stock IMO.

Info on one I just did not long ago. 372 50mm rings pulled from a running saw just getting low on compression 120psi, still ran and started good. Checked cold

Then new Caber 50mm rings with about 30 seconds of run in , idling and blips. Checked warm 140psi

 

[epicklein22]

Well, that makes me feel a little better. I'm gonna at least ring it and check the piston clearances to the jug. Slap a meteor piston in it if needed.

 

[GlenWimpy]

Did you sell the saw? Thanks

 

[epicklein22]

It's still available. I'm going to fix it this week hopefully.

 

[Eiler2641]

Just wondering if the saw sold yet?