Hello . I'm from Romania and I have a problem with the Husqvarna 545RX mower. please do not delete this message, please. I made some videos. so I went to an authorized Husqvarna service and my carburetor was adjusted to 11500 rpm, after the problems started, namely: the engine has fluctuation at maximum acceleration. I cleaned the carburetor and took off the L jigler, bought the carburetor repair kit, and replaced it , less the oring from kit repair. and the engine has very high speed fluctuations.
Husqvarna 545 RX , please don’t remove this . Please help
- Thread starter clauss_ro
- Start date
Help Support Arborist Forum:
Sounds like its a tad rich and 4 stroking or it's hitting the rev limiter.
I do not understand, can you please explain more clearly please?
Kinda agree with Sean.
But put a new plug in and then cut some brush for 10 minutes and then post a pic of the plug.
You are adjusting the wrong screw if it's the L. That is for off idle to full rev responsiveness. The H controls top end and cutting power. It should 4 stroke or fluctuate at wide open throttle when correct. But should clear and stabilize under load cutting. There's alot at stake there so if you done alot of adjusting take it back to the dealer and own up to what you have done so far. Those brush cutters aren't cheap.
But put a new plug in and then cut some brush for 10 minutes and then post a pic of the plug.
You are adjusting the wrong screw if it's the L. That is for off idle to full rev responsiveness. The H controls top end and cutting power. It should 4 stroke or fluctuate at wide open throttle when correct. But should clear and stabilize under load cutting. There's alot at stake there so if you done alot of adjusting take it back to the dealer and own up to what you have done so far. Those brush cutters aren't cheap.
Get a new NYLON air filter,not the "felt" one.
First I'd try what TLG suggested and see if it sounds better when you are cutting with it. If it still sounds wrong I'd try cleaning or replacing the filter, and if that doesn't help have the dealer lean out the high end just a smidge.
Ok thanks
