Jonsered 2077 build

[kbsd]

Is that the original cylinder?

Sent from my Moto Z3 Play using Tapatalk

 

[huskyslinger]

Yes it is

 

[kbsd]

I was afraid that was your answer. I've been looking for a cylinder for a 2083 I aquired.

Sent from my Moto Z3 Play using Tapatalk

 

[huskyslinger]

is yours the 52mm or 54mm?

 

[kbsd]

It's a 54mm

Sent from my Moto Z3 Play using Tapatalk

 

[huskyslinger]

how bad is your cylinder?

 

[kbsd]

It's pretty deep, and vertical. It looks like the ring broke, and broke through the upper part of the piston.

Sent from my Moto Z3 Play using Tapatalk

 

[huskyslinger]

post me a pic

 

[kbsd]

I will this weekend, won't get a chance until then.

Sent from my Moto Z3 Play using Tapatalk

 

[RedneckChainsawRepair]

OP check your green coil to see if it is the rev limited ones to around 11.5K. Cant stand those and pull them.

I sell all the 52's off NOS and used to help others. I just keep the 48 50 quads and 54's around. I just put my last 54mm on a build because of this crap. Couple 54's with pistons.

Even have nos 1 ring and 2 ring pistons. Last build I used the 2 ring.

 

[RedneckChainsawRepair]

It's pretty deep, and vertical. It looks like the ring broke, and broke through the upper part of the piston.

Sent from my Moto Z3 Play using Tapatalk

Had a 2083 54mm come to a halt in cut 28" buried in ash. Turned out crank cracked. Took out p+c.

 

[kbsd]

My apologies, it's a 52mm piston.

Sent from my Moto Z3 Play using Tapatalk

 

[Yotaismygame]

My apologies, it's a 52mm piston.

Sent from my Moto Z3 Play using Tapatalk

You could run that no problem.

 

[kbsd]

I'm more than likely going to. Won't have much $$ in it so why not.

Sent from my Moto Z3 Play using Tapatalk

 

[AUSSIE1]

Huskyslinger, beautiful work.

 

[Yotaismygame]

Huskyslinger, beautiful work.

Yep! But does it run good? Huskyslinger keeps leaving us in the dark with his builds.

Video! Video!

 

[AUSSIE1]

Yep! But does it run good? Huskyslinger keeps leaving us in the dark with his builds.

Video! Video!

The unfortunate thing is some people just dont do videos.

His work is very neat. Ive never gone beyond the ‘rough in’.

 

[Yotaismygame]

I’m not knocking him at all. Half the fun is seeing the final result. Glad someone else is willing to post up some port work.

The finish work hardly takes any time. Split mandrel and some sand paper.

 

[hillwilliam]

Yup, it looks like some mighty good work!

 

[AUSSIE1]

I’m not knocking him at all. Half the fun is seeing the final result. Glad someone else is willing to post up some port work.

The finish work hardly takes any time. Split mandrel and some sand paper.
View attachment 835168View attachment 835169View attachment 835170

Personally i dont see the benefit hence why i dont bother. It certainly looks impressive.