Jonsered 451 E EV Chainsaw Starter/Recoil Cover

[digiacomor]

I replaced the pull cord on my Jonsered 451 EV because the the pull cord was only about 14" long. How long should it be from the factory? It was hard to start because of the small cord. I can't seem to get the spring to wind back any further with the new pull cord that I put on. Is the spring worn out? Does anyone know what the part number for the spring would be? Does anyone have an 451 or compatible recoil cover and starter rope, that I could buy to just bolt onto my saw? Thanks in advance. Bob

 

[digiacomor]

I was able to find the part number for the spring I am looking for 504-21 00-17
any one have one for sale, or know where I can order it from? Thanks Bob

 

[bama]

Send me a PM with your e-mail address and I will send you a manual that should help with the starter rope install. It's easy to do once you have done it once.

 

[MKranz]

Send me a PM with your e-mail address and I will send you a manual that should help with the starter rope install. It's easy to do once you have done it once.

If you still have that Manual will you send it my way? Going thru the same thing. Thanks in advance.

 

[bama]

If you still have that Manual will you send it my way? Going thru the same thing. Thanks in advance.

 

[bama]

Let me know if you need anything else. I am not on often, but will help when I am on.

 

[Piotr Pakuła]

Let me know if you need anything else. I am not on often, but will help when I am on.

Is this manual available in PDF? I just found 451 and 452