Want to Sell Large Remington Nos parts lot

[shortfuze82]

Above sl7 cylinder has pitting in chrome and will need replated before use

 

[shortfuze82]

Air filters condensers stator plates ,

 

[shortfuze82]

2.5” roller noses, clutches/ clutch parts

 

[shortfuze82]

Morse starter pawl assemblies used on a wide range of old saws , narrow and wide sets, also have friction washers as well as D metal washers to match

 

[shortfuze82]

Tons log connector links some Oregon brand some off brand for 1/2”- 9/16 chain I do believe

 

[shortfuze82]

Original molded fuel ones/ cotton filters as well as the oem adhesive backed intake gaskets , fuel caps all Nos and not swelled up from this garbage fuel ...

 

[shortfuze82]

95cc three ring pistons

 

[shortfuze82]

Smaller bore cylinder unsure of model ?

 

[Maintenance supervisor]

Is that a unused pl7 cylinder?

 

[shortfuze82]

Yes it’s Nos but the chrome is pittited up in compression zone it will need replated , I have pistons to match

 

[shortfuze82]

Also have a bunch of Nos never used tillotson hs carbs models as follows:
Hs-19a
Hs134a/2
Hs 80a
Hs 129a part number 67020

 

[shortfuze82]

2/ pl- 55 cylinders 82cc part number 65860

 

[Modifiedmark]

Whats the Wico part number on those condensers?

 

[shortfuze82]

Will part out piece by piece but would very much like to sell the entire lot as a whole . Local pick up only so buyer can sort

Whats the Wico part number on those condensers?

 

[Modifiedmark]

Will part out piece by piece but would very much like to sell the entire lot as a whole . Local pick up only so buyer can sort

Yeah I know but just wanted to see what they were, I have some here that I thought might be the same. Thanks.

 

[shortfuze82]

Yeah I know but just wanted to see what they were, I have some here that I thought might be the same. Thanks.

Yea ,pretty many saws used the same ones over those years pretty common knowledge

 

[shortfuze82]

Bunch of Nos gaskets as well as oem tillotson gasket kits for hL carbs used on MANY old model saws

 

[shortfuze82]

Yea ,pretty many saws used the same ones over those years pretty common knowledge

I have a few diff ones as well for the smaller models in the box lagged ignition part

 

[shortfuze82]

Also avail is a Nos mall mount bar with enough of the special chain to spin a loop and I believe I do have the special links to put it back together, also pictured is a chain repair kit for Remington brand chain

 

[Yukon Stihl]

Hi Again
How is your selection of roller tips?
I have a bar with a bad one.