MAC super 250 drive

[jheinzle]

Any one of you amazingly knowledgeable fellas know if a drive sprocket for any modern saw will fit a MAC super 250. I'd like to get to a rim drive if possible. I have machining capability if some mods are needed.

Also, I have the 600100 with ser# beginning with 12-. Is the only difference between this super 250 and the "other" super 250 the 87cc vs 80cc size? Do any of the drive parts cross-over?

thanks guys

 

[Justsaws]

Any one of you amazingly knowledgeable fellas know if a drive sprocket for any modern saw will fit a MAC super 250. I'd like to get to a rim drive if possible. I have machining capability if some mods are needed.

Also, I have the 600100 with ser# beginning with 12-. Is the only difference between this super 250 and the "other" super 250 the 87cc vs 80cc size? Do any of the drive parts cross-over?

thanks guys

You can order one from any Oregon dealer. Somestimes it takes a while but it is worth the wait. Tilton/Total also has them. The rim/drum combo that I last purchased was around $16.00. All the 250 series saw drive parts will inter-change. Good luck, they are a fun saw in good working order.

 

[jheinzle]

Oregon's website doesn't show anything in their "selector" for my saw. Do I have to call a dealer and have them cross the part number? Do you have a knowledgeable dealer you like?

There is a weasel trying to sell me a new one for $35. Of course he says Oregon doesn't make 'em anymore.

thx again

 

[mbopp]

Here's my source for Mac parts:

http://www.fayettevilleequipment.com/McCulloch Parts.htm

Most likely Bill can answer your questions & get you parts.

 

[romeo]

Yours isn't a rim drive? Mine is, it uses large oregon spline and came from the factory that way. So they are available. Lots of Mac parts will interchange with you 250's, the old macs are pretty adaptable. I think that most of the 80cc junk will interchange which gives you options from 1-41's through 300's when your looking for parts.
http://www.acresinternet.com/cscc.nsf/ed1d619968136da688256af40002b8f7/b8ec30eb359ff47588256b62001c6a41?OpenDocument

 

[gatkeper1]

1975 Oregon catalog shows for S250 # 10624 for use with 1/2" bearing
10608 fits the other 250's