ms clone

[Muzzleblastm38]

is the ms 660 clone is a good saw for milling,and it compare to what brand for durability
thanks for the reply

 

[ammoaddict]

Are you referring to the kit parts or the complete blue saw? Lots of YouTube vids and reviews of both.

Sent from my Moto G (4) using Tapatalk

 

[Muzzleblastm38]

Parts kit. I have use poulan 4218 and 5020 for years. Is it more durable the ms660 kit or a poulan

 

[ammoaddict]

660 kit is very durable if you take your time and build it right. Have you watched any videos yet?

Sent from my Moto G (4) using Tapatalk

 

[Muzzleblastm38]

Yes I saw one video. No assembly lube like four stroke engine?

 

[ammoaddict]

I used 2stroke oil.

Sent from my Moto G (4) using Tapatalk

 

[Muzzleblastm38]

Ok thanks i just order the kits this Saturday can’t wait to mill with a real saw
My poulan 5020 is so slow

 

[cuinrearview]

There's a group buy for these POSs being organized on one of the sites. Probably save you some coin.

 

[stihl_lyfe]

I took a chance on one of these a few months ago and so far haven't regretted it. Bought especially for milling, used OEM decomp, wrist pin and piston bearing and hasn't skipped a beat in the >30L of fuel that I've put through it now. Measured pretty high compression (0.17 squish) with factory paper base gasket, but use high octane gas and 40:1 with genuine stihl oil and is muffler modded. Started milling duties on the third tank and been running 42" and 32" bars and it is happy. Long may it continue - with the number of slabs I've cut I'm already feeling like I've got good value but could blow up tomorrow I spose

 

[ammoaddict]

I took a chance on one of these a few months ago and so far haven't regretted it. Bought especially for milling, used OEM decomp, wrist pin and piston bearing and hasn't skipped a beat in the >30L of fuel that I've put through it now. Measured pretty high compression (0.17 squish) with factory paper base gasket, but use high octane gas and 40:1 with genuine stihl oil and is muffler modded. Started milling duties on the third tank and been running 42" and 32" bars and it is happy. Long may it continue - with the number of slabs I've cut I'm already feeling like I've got good value but could blow up tomorrow I spose

View attachment 769471

There are tons of these kits being used all over the world exclusively for milling. I have only heard of a few of them failing. They hold up very well. The kits are getting better and better. I have an earlier one and had several problems with it. But it does run very well. I just wish they would come out with more Husqvarna kits. I have one of their 365/372 kits and it is an absolute beast. It runs very very well. If they would start making a 346xp kit, they would sell like hotcakes. I have heard talk of a 288xp kit but haven't seen one yet.

Sent from my Moto G (4) using Tapatalk