david newbie
Addicted to ArboristSite
Has anyone had this problem? I just finished rebuilding a decent husqvarna 50 white top saw, starts and runs nice. However, the chain does not seem to be getting oil. I took off the bar, and it seems like oil is coming out of the hole in sort of a pulsatile manner, but the oil comes out. I put the bar back on with just washers so I could see what was going on, but bar groove seems dry. I though maybe oil was escaping through the unused upper adjustment hole, so I covered that one with metal tar on the outside to act as an outer bar plate, put bar back on with washers, still dry. Im using an old small mount husqvarna bar, and I enlarged the oiler holes in bar with a 3/16 bit, didnt help. Could the pump be too weak? Should I go find a dumpster?!!?






