New Echo CS-355T

[HansFranz]

Thanks. I'm a tig welder and I can make something like that fairly quick from scrap that I have lying around.
I would guess that you need to open up the carb a LOT for that...particularly at sea level.
Rochester 650cfm double pumper...

Gotta love a 3" blue flame out of a tree saw with chips flyin out like it's a snowblower

 

[HansFranz]

Oops, not west coast...
https://eganperformancesaws.com/collections/exhaust-pipe/products/echo-355-pipeView attachment 1209344

Is that your saw? If so, do you know the inside diameter of the pipe?

 

[singinwoodwackr]

Is that your saw? If so, do you know the inside diameter of the pipe?

Yes, I'll get you specs. Imo, they used a heavier guage than needed.

 

[HansFranz]

Yes, I'll get you specs. Imo, they used a heavier guage than needed.

SWW -- Did you by any chance get that inside diameter?

Don't go to any trouble to get it ... since I can probably just make the inside area of the pipe 85% of the port opening area and then choke it down from there with a screen if need be (I think 85% was the rule of thumb)...

 

[singinwoodwackr]

SWW -- Did you by any chance get that inside diameter?

Don't go to any trouble to get it ... since I can probably just make the inside area of the pipe 85% of the port opening area and then choke it down from there with a screen if need be (I think 85% was the rule of thumb)...

3/4" od. 1/16" wall