Nik's Poulan Thread

[JonCraig]

"Thumper"

 

[Boomer 87]

Im not gonna lie that was totally me haha. Just listening to it thump away at idle it seemed so fitting. I can wipe it off when I decide I was being a child lol.

 

[JonCraig]

My favorite sounding saw is an 041. Just really distinctive. Sounds like I need to hear a 655, huh?

 

[Boomer 87]

If you need to jack hammer concrete just fire up the 655 and set her on it lol.

 

[Acornhill]

You should run an R12 Partner or a 91 poulan.

Sent from my LG-D800 using Tapatalk

 

[RedneckChainsawRepair]

I like the 166 for sound at idle. Only thing I like about the dang saw.

Just a follow up. Hangs in their new house in the puter room.
Someday I'll get one painted. Dad had this one painted 35 or more years ago.

 

[RedneckChainsawRepair]

166 idle as I was tuning it. Woods ported.

 

[Boomer 87]

Hard to beat the old 4200/5200 for an aggressive exhaust note must be like a 1" outlet

 

[Just a Guy that cuts wood]

Playing with my toys

 

[Just a Guy that cuts wood]

Ear muffs a Must

 

[jerrycmorrow]

Anyone got a complete clutch cover for a 306A? Someone in the past tightened the bar nuts down without seating the cover. Result - 4 cracks; foot is gone too though that mayve been a separate issue. Got lots of Poulan stuff to trade

Bump II

 

[Acornhill]

Ear muffs a Must

you should tune that saw and sharpen the chain, that saw was not performing like it should.

 

[MS460WOODCHUCK]

Ear muffs a Must

Take the muffs off the ears and tune it...

 

[Just a Guy that cuts wood]

you should tune that saw and sharpen the chain, that saw was not performing like it should.

Thats where you guys come in . I have it running rich for now summer heat . thats the third big round cut six ways .
I thought it would run out of fuel in the cut .

 

[Boomer 87]

Maybe just a little fat once in a while you can hear it come to life then go back to burbling, I've gotten to the point that I have brother come over we fatten them up pig fat rich, then go to cutting, while he SLOWLY starts to lean it out the moment it stops all the burbling he stops and we're done

 

[MS460WOODCHUCK]

Lean it out a bout 1/8 of a turn and see if it still burbles when ya let up on it a little in the cut.

 

[Boomer 87]

Unless.you got an limited coil there more challenging

 

[Just a Guy that cuts wood]

I will start to lean it out over the weekend and post that
I will be the first to say I know nothing of 2 strokes but am willing to learn

 

[Boomer 87]

Your just a little heavy every now and then I hear it clear up for a split second then start 4 stroking again just a smidgen leaner would prolly do the trick, always err to the rich side then slowly go leaner till you hear it run clean in the cut then raise up off the wood it should go back to 4 stroking.

 

[MS460WOODCHUCK]

Unless.you got an limited coil there more challenging

No problem...