Partner Chainsaw Thread

[leecopland]

If it has a 7000+ cylinder you will see the T port through the exhaust window

I have not had a chance to remove the muffler yet.

 

[Piotr Pakula]

He showed you in the picture above

 

[leecopland]

Had a look this morning no T port. From the service bulletin above it looks like only the P100 and K1200 got it.

Anyway the P&C look great. I sprayed some lub into the cylinder to help free the rings if stuck. Will need some servicing before running and cutting.

 

[Piotr Pakula]

It's either you have 7000 without + or someone has replaced the cylinder ;-) 7000+ can also be recognized by the cylinder number

 

[leecopland]

It's either you have 7000 without + or someone has replaced the cylinder ;-) 7000+ can also be recognized by the cylinder number

Model plate says Partner 7000 serial is 7010401. Top cover says 7000 Plus

 

[Piotr Pakula]

The number is on the base of the cylinder

 

[leecopland]

What is the number for 7000+?

 

[Piotr Pakula]

I would have to see a good question in my own because I don't remember and read about it on the Swedish forum. What is your cylinder number?

 

[leecopland]

On the clutch side there is an A and 341290

 

[KASH]

Jeffy06 sent you a pm.
Kash

 

[Piotr Pakula]

You have to look for the coil side

 

[Piotr Pakula]

Undoubtedly, the eye pleases the eye, although too expensive for me ;-) Partner C6.

 

[leecopland]

My 7000 came with just one bar plate and the chain, on a partner bar, doesn't move freely. Does this mean that I need two bar plates? I have a F55 and a F65 which both have two bar plates and the chain moves easily with you fingers, saw not running of course.

 

[Piotr Pakula]

I use it without these tangs / bar plate. Maybe the dimensions do not match or there is a blocked groove in the guide

 

[RedneckChainsawRepair]

Never thought I would be in these again after selling them out in 2010.

Partner 500 open port and partner 5000 closed port. Both do start and idle.

Just ugly from doing what chainsaws suppose to be doing.

 

[Piotr Pakula]

You can do it . I believe in you :-D & Fingers crossed

 

[Huskybill]

I have a few partner saws. The 400’s, 500’s, p85, a R12 and P100. Haven’t played with them yet I think the p85 needs the points cleaned. They all have compression. I’d like to set the 100 up with a big bar I have large trees to buck up.

 

[Huskybill]

Sorry my big partner is a R40 never started it up. It’s heavy. How good do these cut?

 

[Piotr Pakula]

There is no stronger Partner, but for thinner trees it is simply too heavy ;-)

 

[RedneckChainsawRepair]

After selling the partner 5000 plus topend. I had decided to use the parts from it to finish up the partner 500 49cc.
She lives and cuts good.
Someday a better clutch cover will turn up or someone else can do it.
Still even has the shrunk fuel line that allows seep by tank hole. Just wanted it running good first.

After using wd40 cleaner to remove the grime.