Partner Chainsaw Thread

[heimannm]

I don't know if they are all the same (I've heard some P100's had a different mount) but my PM1000 uses a D176 mount like the 10 Series and 600 Series saws. The oil passage is through the upper "adjuster" hole, you can see in your photo that the groove intersects the hole for the oil to pass though.

Looking at my saw, I am guessing that piece of aluminum is just a heat shield/reflector to keep some cylinder heat away from the top cover. I also see that I am missing a clip...



That ring sort of looks like the piece that engages the spring on the starter pulley. If it were missing from yours the recoil would not work. Can't help much with that request.



Mark

 

[flatsfisher]

I'll see what the guide I got with the saw looks like

thanks Piotr.

 

[flatsfisher]

I don't know if they are all the same (I've heard some P100's had a different mount) but my PM1000 uses a D176 mount like the 10 Series and 600 Series saws. The oil passage is through the upper "adjuster" hole, you can see in your photo that the groove intersects the hole for the oil to pass though.

Looking at my saw, I am guessing that piece of aluminum is just a heat shield/reflector to keep some cylinder heat away from the top cover. I also see that I am missing a clip...

View attachment 1222331

That ring sort of looks like the piece that engages the spring on the starter pulley. If it were missing from yours the recoil would not work. Can't help much with that request.

View attachment 1222332

Mark

hi Mark. I looked at my bar again just now. had scraped out the grooves but had not realized that there are big passages from the grooves all the way down to the 2 holes above and below the bar stud slot that were plugged with black grunge. still, this is way different than most bars that have small holes right at the slots. so, with this bar, the oil would have to go into the bottom slot only instead of the top slot. I looked at D176 bars online just now and they seem to oil the top slot. need to look at one of my other MAC bars when I get home.

 

[Piotr Pakuła]

hi Mark. I looked at my bar again just now. had scraped out the grooves but had not realized that there are big passages from the grooves all the way down to the 2 holes above and below the bar stud slot that were plugged with black grunge. still, this is way different than most bars that have small holes right at the slots. so, with this bar, the oil would have to go into the bottom slot only instead of the top slot. I looked at D176 bars online just now and they seem to oil the top slot. need to look at one of my other MAC bars when I get home.View attachment 1222341

View attachment 1222339View attachment 1222340

D176 definitely has too small a gap for 8mm pins / I have it on Homelite SXLAO / The P100 has a large assembly from the large Husqvarna D009 The studs I have, if I remember correctly, are 3/8" and 9.5mm

 

[flatsfisher]

found this pic of the D176 from my SP70. it has the normal oil hole that goes into the side of the upper slot adjacent to the oil pump outlet. so the big bar I just bought a new chain for is obviously not a D176 bar. crap. it says McCulloch on it, wonder what it went to?