Not popular so they don't usually go for much. That one appears to be missing the primer.
Pioneer chainsaws
- Thread starter WesternSaw
- Start date
-
- Tags
- operator manual
Help Support Arborist Forum:
Not popular so they don't usually go for much. That one appears to be missing the primer.
Even if the primer body was still there the inside rubber would be mush by now.
I contacted him yesterday to see if he may be interested in a trade. Said he'd consider a large cc Stihl.
Now I know why he still has it.
Now I know why he still has it.
The green Pioneer?
Yes.
You’d need two large Stihl to make that a fair trade!!
Not in my world.
My Farmsaw (purchased new in 79) does a fine job with both 20" and 24" bars. You'd be hard-pressed to convince me that Stihl has anything on my Pioneer!
Actually my 359 Husky does a good job with both 20" and 24" bars too.
The Pioneer is pretty much retired today but she is my backup saw if ever she's needed. I fired her up a week or two ago, She still runs as she did once she was broken in.
Actually my 359 Husky does a good job with both 20" and 24" bars too.
The Pioneer is pretty much retired today but she is my backup saw if ever she's needed. I fired her up a week or two ago, She still runs as she did once she was broken in.
Dreamer!
I’ll measure mine tomorrow thank you. If it is I would be willing to trade straight across for one or sell it if anyone is interested
Or a 064, or a.....
Mike Acres
ArboristSite Operative
Another little bit of trivia about the family of saws starting with the P40. The P40 started with 5/16 in. bar studs and no chain brake. Later in the production a chain brake was added with holes matching the 5/16 in. studs. Then the stud size was changed to 3/8 in. The P41, P50, P60 and everything that followed had the larger studs. The P50 and P60 started out with no chain brake and they were added later.
Hmmmm maybe mine is a p40 I can’t remember
was looking at a very worn model 650. really like the look and design of these old saws. I like to redo old chainsaws including prepping and re-painting. this would be a good candidate as it has almost no paint left on it, and I don't like to paint old tools that still have a good finish.
when I do this, I want the saw to be running, even though I may never use it, or maybe just a little. are parts available to get one of these up and running?
thank you.
when I do this, I want the saw to be running, even though I may never use it, or maybe just a little. are parts available to get one of these up and running?
thank you.
nice looking saws!
ML12
ArboristSite Guru
Thankfully most of the IEL/Pioneer parts are standard sizes so seals and bearings are pretty easy to get. Gaskets are easy, and they pretty much all use basic normal fuel lines. Only bad thing are the OMC carbs that some of them use.
And since we are sharing restored saws:
IEL HM and HC
Pioneer 700
IEL RA under restoration
Other side
Pioneer 1750
And since we are sharing restored saws:
IEL HM and HC
Pioneer 700
IEL RA under restoration
Other side
Pioneer 1750
wow. well done. what paint and paint method are you using on those?
and the metal casting they did on these back in the day is exquisite.
Similar threads
- Locked
