Project Stumpbroke Makita 7900

[Stumpys Customs]

I cut the muff apart to gut it

 

[Stumpys Customs]

Aint she purdy

It don't run half bad either.:msp_thumbup:

I've got a vid loading right now.

 

[fastLeo151]

​

Stump,

What are you using to lay out you ports so nice?

Must be a secret....

 

[Hedgerow]

:beauty3::beauty3::beauty3:

That saw is just eye candy...

 

[Stumpys Customs]

Here it is with an 8 pin rim & 28" b&c
[video=youtube_share;c4NFS6T1C4k]http://youtu.be/c4NFS6T1C4k[/video]

 

[Hedgerow]

Here it is
[video=youtube_share;c4NFS6T1C4k]http://youtu.be/c4NFS6T1C4k[/video]

Getting a big negatory on the vid...
Nevermind...

 

[Hedgerow]

14.3 and 14.2

 

[benp]

Very Nice Stumpy!!!uttahere2:

 

[Stumpys Customs]

Stump,

What are you using to lay out you ports so nice?

Sorry I wasn't trying to ignore yer post buddy. I use this

ANd the piston and a ring to do the horizontal lines.

 

[blsnelling]

Is that about how much you raised the transfers? I'm assuming you dropped the cylinder with a squishband mod?

 

[mdavlee]

Looks great stumpy

 

[fastLeo151]

Sorry I wasn't trying to ignore yer post buddy. I use this

ANd the piston and a ring to do the horizontal lines.

Thats very fancy. Me likey

 

[Warped5]

Really nice work, Stump!

 

[sarahdodgegeek]

Benp-How's it compare to your winner?

 

[Stumpys Customs]

Stump,

What are you using to lay out you ports so nice?

Is that about how much you raised the transfers? I'm assuming you dropped the cylinder with a squishband mod?

Yes I dropped the cyl .050" & cut the sq band the same.
Hows the 390xp doin??

 

[Stumpys Customs]

How's it compare to your winner?

It's a 28" bar so it's got about 26" on me. Not used to such personal ?'s though:hmm3grin2orange:







What winner are you talkin about?

 

[Dan_IN_MN]

Yes I dropped the cyl .050" & cut the sq band the same.
Hows the 390xp doin??

That's a mile in a saw cylinder IMO! Was there any platting left in the top? Or were you counting on the rings being down on the piston?

 

[benp]

Benp-How's it compare to your winner?

LOL - I'm the wroooong person to be asking. I'm just some firewood schmuck that won a kung fu - kicken saw, not a good judge of comparing.

In my mind they are all lightsabers....



Eric would be the correct one to ask. :msp_thumbup:

 

[Stumpys Customs]

That's a mile in a saw cylinder IMO! Was there any platting left in the top? Or were you counting on the rings being down on the piston?

It has .144" from the top of the piston to the top of the ring. Add .020" for the squish gap = .164". then take away .050" & I still got .114" from the top of the ring to the top of the cyl. Plenty of plating left for the ring to ride on.

 

[atvguns]

It sure would be nice if that saw could make it to the gtg hint hint