Ran my big saws and a few small ones last Saturday

[Anthony_Va.]

Anthony va and bryanr2 thanks. I really love the 660 and makita... Great old school saws.

Anthony I hope you still like the 441c

Yea funny about the echo... Great saw though.

I'm digging the 441C my man. I've got it ported now, and just put a new 28" Stihl light bar on it. It's a tree killing machine now. Glad you're liking the 660. She's a good saw. it had'nt been ran much as you can probably tell.

 

[zogger]

The Echo is lean on the L. That's why the throttle response is so poor.

Thanks, I'll check that.

 

[Mastermind]

Sharp and fat Josh.......don't let em run lean or dull and they will last you a lifetime. :msp_wink:

 

[josh1981]

That's great Anthony and yes I can tell... I have a 28 light bar too. They are great.

Hoping you'd see thus post randy. Thanks for the info. Went through 2 chains...

 

[Mastermind]

Josh your PM box is full brody.

I listened to the video on the laptop.....You need to turn the low speed screw out just a little and idle it up afterward. Make sure it's warmed up good before you call the idle good. You'll learn.

Yes you can convert to 3/8 by changing the rim and the bar tip.

 

[zogger]

Josh your PM box is full brody.

I listened to the video on the laptop.....You need to turn the low speed screw out just a little and idle it up afterward. Make sure it's warmed up good before you call the idle good. You'll learn.

Yes you can convert to 3/8 by changing the rim and the bar tip.

You weren't joking on that 084 being a bit of an effort to start! I got that yanked fingers out effect on it! After one good ouchie I did it though. ha! I need an engine like that on my slow ped....

It was cool to check out two of your builds, good work there.

 

[Mastermind]

You weren't joking on that 084 being a bit of an effort to start! I got that yanked fingers out effect on it! After one good ouchie I did it though. ha! I need an engine like that on my slow ped....

It was cool to check out two of your builds, good work there.

Josh needs a D handle from a rescue saw on that 084. :msp_unsure:

Thanks for the nod.......we try. :msp_thumbup:

 

[josh1981]

Box is empty now.

I will fix the idle next time I run it.

Going to throw a 3/8 sprocket on it and elastostart handle or similar.