Sdc carb identification

[vtsalmon]

Hello everyone I picked up this sdc carb for maybe a swap on my pro Mac 55 I believe it is a sdc 49 but I have not seen a fully adjustable one before . I am I right ?if so what model saws would this have been on . I appreciate any info as I am still fairly new to working on these saws . Thanks again

 

[Woodslasher]

We need a picture of the flip side of the carb, the model # should be on one side of the tit the alignment hole in the diaphragm fits over.

 

[vtsalmon]

So I took a pic of the flip side . I do not see any # or marking there . Is there any other way to tell ?

 

[HarleyT]

Show us your tit!!!

Sorry, I had to say it....

Put up a pic of the side with the fuel inlet nipple.

So, show us your nipple!!!

 

[Woodslasher]

Hmm, in that case I'd say SDC 3.

 

[HarleyT]

Looks like this one a bit.
https://www.ebay.de/itm/15513002937...8S9Fmc4cQj25a28oNCVoEiaA==|tkp:Bk9SR_iKyeXaYA

 

[vtsalmon]

So HarleyT here is the nipple shot you wanted . So if it is an sdc 3 would I be better off looking for a 37 or 65 ?
I want to thank everyone for all the info it is greatly appreciated.

 

[Woodslasher]

So HarleyT here is the nipple shot you wanted . So if it is an sdc 3 would I be better off looking for a 37 or 65 ?
I want to thank everyone for all the info it is greatly appreciated.

What's it in? For a 10-10 or something like that it'll be fine. On a SP81 or SP125 that's a different story.