Want to Sell Slant fin 10mm 044 & 12mm slant fin 440

[Cas101326]

I have a slant fin 044 10mm I acquired last year. As far as I know the saw is all original. Has the KS cylinder. Shows 155psi. It starts and runs ok, but to be 100% honest, running it I wouldn’t have expected compression to be 155, it seems a little lower than that when you run it. I also have a 440 with a 12mm crank and a Mahle slant fin cylinder I installed. Has a brand new oem Stihl piston installed when I put cylinder on. As you can see pictured I put red lever, and plastics off 044 on it when I put the cylinder on. Saw probably only has 1.5-2 tanks on it since rebuild. It runs good. Shows 150psi and honestly I was surprised it wasn’t more, feels like more to me when cranking or holding up by rope but checked twice with gauge. Was looking to get $500 each PHO plus shipping. Wanted to keep these in collection but wife’s car came home pouring oil yesterday and we are probably gonna have to dig deep to get this all figured out. Feel free to message me with any questions. I also have a 281, 266, and a 261 with HDA 87 and KS cylinder off of 262, jonsered 630, stihl 036, and a red top Dolmar 6300 that are all running saws, honestly hate to sell any of these but we may be looking at getting a new vehicle. Also have some project saws that may be of interest, have a red light flat top 066, some 268’s, 266, 460.

 

[Cas101326]

Here’s the 440 with the Mahle slant cylinder

 

[joshuapc]

Any info on the project stihls?

 

[Mad Professor]

Should have gave the saws a bath before you took the pictures.