Swap meet...

[cutforfun]

Looking for the manual oiler button for a mcculloch cp 125
Thanks as always

 

[scallywag]

Stihl 090G

I know i'm asking the impossible, but has anyone got a crank case for a stihl 090G ?? or just the right hand side of the case will do the trick.
Cheers Phil.

 

[thomas1]

I can use all the FS-74 stuff. I'm building my own custom pole saw.



I have your address, the boot will be en route tomorrow.

How custom? I think I have an ht101, minus the entire shaft. Shaft is only $450 from Stihl.

 

[nstueve]

Needing a 046 stihl top badge for a project saw and also looking for a 024/026 flywheel that's hollow for the heated handle bits.

Also looking for a Stihl BG56 blower carb and muffler...

anyone need some husky dawgs?
Got 6pairs of left side, 3 singles of center, 3 singles of right. PM me!

 

[sefh3]

I'm looking for a TS350 or Stihl 08 recoil for the older Bosch setup. I need the fan wheel also. If you have any or a parts saw laying around I could use the power head. Trying to finish up some of these projects. I have parts and a few $$ to trade.

 

[Modifiedmark]

Needing a 046 stihl top badge for a project saw and also looking for a 024/026 flywheel that's hollow for the heated handle bits.

Also looking for a Stihl BG56 blower carb and muffler...

anyone need some husky dawgs?
Got 6pairs of left side, 3 singles of center, 3 singles of right. PM me!

Incoming pm

 

[atpchas]

Everything is gone except the Echo 290EVL carcass. Thanks to those who offered new homes.

I tried to get rid of this stuff at the GTG this weekend but there weren't any takers. If no one here claims any of it, off it goes to be recycled. If you have something Stihl flavored to swap (consumables like rims, chains, bars with some life left) that would be great, but mostly I hate to throw out something that another saw nut can use. Questions? PM me.

 

[ChainsawmanXX]

Looking for 076 clutch, need asap.

Sent from my LS670 using Tapatalk 2

 

[Jacob J.]

Everything is gone except the Echo 290EVL carcass. Thanks to those who offered new homes.

I could go for the 290 as well.

 

[vw_motorsports]

need a nut

I have a very clean husky 44 that is missing the nut that holds down the top cover. If anyone can help me out it would be greatly appreciated.

 

[3000 FPS]

Looking for the ignition trigger in a Dolmar 119. There is the coil and a trigger. The coil I can find but the trigger I can not. Anyone parting out one of these I am interested.

 

[lwn9186]

In need of a fuel tank and clutch cover for an Dolmar 111. Down to one college student and some cash for trade.

 

[jockeydeuce]

Looking for the ignition trigger in a Dolmar 119. There is the coil and a trigger. The coil I can find but the trigger I can not. Anyone parting out one of these I am interested.

Does your 119 have the black. horse shoe shaped trigger under the flywheel, like a 114??.....I think all the 119's I've seen had a stator plate that looked very similar to a Stihl 056, Bosch electronic.

 

[Duke Thieroff]

Chris

I might pass this saw along....has been switched over to a Zama, sips a little bit of air from somewhere around the intake.....Piston and cylinder in good shape, had some carbon smeared on the piston when I got it.

Fix the leak and ditch the CAT muffler and you'll have one nice little saw in your hands.

I'm interested in other saws, but don't offer me your clapped out Mighty Mite and two used safety chains.


Chris

 

[husqvarnaguy]

I am looking for a set of OEM crank bearings for an 044. PM me if you have something

 

[3000 FPS]

Does your 119 have the black. horse shoe shaped trigger under the flywheel, like a 114??.....I think all the 119's I've seen had a stator plate that looked very similar to a Stihl 056, Bosch electronic.

Yes under the flywheel there is a curved horse shoe coil and then on the opposite side there is the trigger which is similiar looking but of course no spark plug wire coming out of it.

I believe you are correct on the make being Bosch. I do not know about the Stihl 056 I have never seen one.

 

[jockeydeuce]

Yes under the flywheel there is a curved horse shoe coil and then on the opposite side there is the trigger which is similiar looking but of course no spark plug wire coming out of it.

I believe you are correct on the make being Bosch. I do not know about the Stihl 056 I have never seen one.

I'll send you a PM with pics.....Might not be today, though and if you haven't heard from me for a couple days, remind me.

 

[rms61moparman]

I might pass this saw along....has been switched over to a Zama, sips a little bit of air from somewhere around the intake.....Piston and cylinder in good shape, had some carbon smeared on the piston when I got it.

Fix the leak and ditch the CAT muffler and you'll have one nice little saw in your hands.

I'm interested in other saws, but don't offer me your clapped out Mighty Mite and two used safety chains.


Chris

That's a nice looking saw Chris!!!

What is it???


Mike

 

[Duke Thieroff]

That's a nice looking saw Chris!!!

What is it???


Mike

Mike!!!!

It's a 2159 J-red

 

[thomas1]

That's a nice looking saw Chris!!!

What is it???


Mike

2159c

Me likey, whatcha want for it Dook?