The New MS880 AS Compared To An 088

[Deets066]

Hey!...you're not helping my cause.

Yeah Ted I had it all set it my mind that I was goin to sell it to ya, until I read that post and realized that I had better hang on to it You can come run it anytime though.

 

[big t double]

see. thanks a lot sawfun....you've ruined it for me!!!

 

[TBrown]

Randy, you know what the 880 coil limit is? The 361 coil work out for you ok? I am running a 361 coil and seems good. Tached at 13,300 with 25" bar. Scott did a hellavu job, pulls the 41" in red oak like nothing.

 

[Mastermind]

I'm not sure what the limit is.

Yep.......the 361 coil does the trick.

 

[Deets066]

Just in case you guys were wonderin the results of the 088, it is one bad a$$ dude!

I know..... I'll get a video this weekend maybe

 

[Mastermind]

The one with the 361 coil is coming back for more tweaks.

I'll likely finger port it like I did yours Deets....

He wants it to be faster than one of my 660s in small wood. That's a pretty tall order.

I tried to get him to get a bobbed bar and a 12 pin.........but he's looking for more RPM.

We shall see.

 

[Deets066]

Mine has good throttle response and still is very torquey in the wood with a buried 36" bar.

 

[Deets066]

The one with the 361 coil is coming back for more tweaks.

I'll likely finger port it like I did yours Deets....

He wants it to be faster than one of my 660s in small wood. That's a pretty tall order.

I tried to get him to get a bobbed bar and a 12 pin.........but he's looking for more RPM.

We shall see.

Would angling the transfers upward increase flow and rpm? Lose torque, but he ain't lookin for that.

 

[Mastermind]

I'm not sure really.......

 

[Deets066]

I'm pretty sure mine would take an 066/660 in 24" wood if the 066 had an 8 pin 3/8 and the 088 had 9 pin .404

 

[Mastermind]

They were running 7 pin .404......I suggested a 9 .404