Timberbear need help

[UncleJoey]

Just came across one(left for trash). Try to pick it up and i can lift it about 1.5ft before the weight is more than compression. I've had worse compression but they run. Rebuilt carb but can't get it to fire. It has a Walbro HDB carb. How many turns is the default for H and L?

I think I flooded it as before rebuilding the carb, It would run for 2 sec each time I pour fuel\oil into the carb but no joy now and I can't find any standard mix info.
TIA.

 

[heimannm]

1 to 1-1/4 turns open on the H and L, use a good 40:1 mix.

 

[UncleJoey]

I finally got back home from Thanksgiving trip and looked at it. Turns out the kit has a wrong part where the pulses that pump fuel, gas is leaking to the pump and flooding the motor. I found the correct type and ordered it.
Being this part(that floods) is the same as what I found in the carb when I found the saw, I guess the owner tossed it being(using the wrong kit) he couldn't get it to run...

ps. When I first looked at it when I got back, before adding any more fuel, it ran for a second...again so it confirms this saw still has life. Now just to wait for the correct carb kit.

 

[Gord404]

some kits hook over the needle arm an some don't