tree monkeys 2153 deluxe

[tree monkey]

I haven't done very many build threads in the past, and I most likely wont be doing to many in the future. it just takes to much time. I will be as detailed as possible.
the saw is a new in the box 2153 deluxe. (heated handles)
so we start by ......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................and then..............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................or I could--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------but what if I==========================================================================================================================================================================================================================================================================================================================================================================================so then__________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ so there you have it. hope you found this helpfull

 

[tree monkey]

more to come

 

[nmurph]

In.

 

[cuttinties]

With illustrations that detailed, how could there be more? I'm simply flabbergasted by the detailed lines and precise dots.

 

[Warped5]

Just like a 'Randy' thread ... in just one post!!

Amazing!

 

[Deets066]

Looks like a runner

 

[LowVolt]

So I see you used a popup. Why is that?

 

[TermiteBuffet]

So I see you used a popup. Why is that?

I may have lol'd at this

 

[tree monkey]

So I see you used a popup. Why is that?

yes I used a pop up squish band to lower the spark plug

 

[bryanr2]

 

[tree monkey]

I lost the first couple pics, gone, vanished. i'll just have to live without them.

 

[tree monkey]

good looking saw

 

[HuskStihl]

It looks like it might freeport. Oh well, jugs are cheap

 

[tree monkey]

I cut .045 off the base, and .065 off the flange.

 

[tree monkey]

a hand cutter leaves these little chatter marks.

 

[tree monkey]

that's taken care of fast and easy. then check squish, repeat cutting and sanding until I get the squish I want. takes me about 15-30 minutes depending on how much needs to come out.

 

[tree monkey]

looks like .017

 

[tree monkey]

from the time I took the saw out of the box to this point took about an hour

 

[Mastermind]

from the time I took the saw out of the box to this point took about an hour

Old......and slow.

 

[AKDoug]

Scott- Do you cut the base and flange on a lathe?