Walbro MDC 15 high jet needle tip bent

[elittle]

So I'm rebuilding this carb. I took out the high jet needle and the very tip is at an angle. Is this garbage?

 

[elittle]

Its the long one, i think it's the low speed.

 

[elittle]

Well it broke off so I answered that.... fml

 

[Chevboy0167]

 

[elittle]

View attachment 1233749

I ordered one earlier on ebay. It looked correct but with your info i see the part number matches. Thanks for that diagram, that was helpful.

This is the first saw I've ever torn down so I'm pretty dumb about all this stuff.

 

[SteveSr]

I ordered one earlier on ebay. It looked correct but with your info i see the part number matches. Thanks for that diagram, that was helpful.

This is the first saw I've ever torn down so I'm pretty dumb about all this stuff.

Well, If that needle was in the carb then the carb is probably ruined as well. The steel needle is MUCH harder than the carb body.

 

[elittle]

The saw was running almost fine. Started and idled fine. It was dying after cutting though.

 

[elittle]

I was able to find a used carb on ebay last night. It was like the last one on the planet or something. Really hard to find this kind.