What's on your bench

[Deleted member 117362]

On mine, waiting for sealant to set, then vac test. Then set it aside, no big rush, firewood is done for this year.

 

[Yotaismygame]

The 044 is now rebuilt and ported. Just need to finish assembling

 

[lostone]

A bench is what is on my bench. I am getting a bit older and grey is replacing what isn't falling out. Usually when I worked on things I would just do it outside no matter the temp or in an unheated building but I work outside year round and I am wanting a break so I built a small work bench in the house that I can mess around with things on in an old room we use for storage.

 

[Yotaismygame]

I’ve been away for work so this project is taking a little while. Just need to finish the muffler and run it.

 

[Goofaroo]

I finally got some time in the shop and got this little Echo up and running. I cleaned and kitted the carb, dressed the bar, and sharpened the chain. A bit of tuning and it runs and cuts great. I’ve got less than $30 invested and I’m either going to use it for small jobs or maybe keep it on my motorhome for camping duty.

Of all the saws I’ve resurrected the Echos are by far my favorite to work on.

 

[Deleted member 117362]

This beauty, rebuilding it for when they take my driver's license away. I can use it to drive around town. Sweet ride isn't it?

 

[motorhead99999]

My bench is a mess from a generator cobbing job but there is a pile of saws on the floor and about 4 more piles in the other garage if that counts for anything

 

[Yotaismygame]

I just need to run it. Lot of elbow grease into this one.

 

[James Miller]

This one just came off the bench. New rear handle and fuel system parts. Going back on the bench for bg delete, mm, and maybe some tinkering with the transfers and intake block.

 

[buttercup]

My custom tailored chain sharpener progressing...

 

[Yotaismygame]

My custom tailored chain sharpener progressing...

View attachment 771009

I’d like to hear more about this

 

[Yotaismygame]

Got her done. 180 comp before break in
https://youtu.be/qJrhZm38sOk

 

[James Miller]

I'll be happy if my 3.7 makes 150 with the gasket out.

 

[Yotaismygame]

@Duce is up to bat

 

[2broke2ride]

Currently this homelite is taking up bench space. Waiting on an oil line and a bucking spike for it.
I will soon be getting back to my Mac 1-86. I got frustrated and shelved it in the spring. It needs to come back apart to revisit some problems and perhaps repaint the repaint.

 

[Yotaismygame]

Currently this homelite is taking up bench space. Waiting on an oil line and a bucking spike for it.
I will soon be getting back to my Mac 1-86. I got frustrated and shelved it in the spring. It needs to come back apart to revisit some problems and perhaps repaint the repaint.

That’s hot

 

[Yotaismygame]

Ready for a squish band cut and all measured up.

 

[Deleted member 117362]

Ready for a squish band cut and all measured up.
View attachment 771272

Nice, base holds 7lb vacuum for over 20 minutes and will be waiting. No rush. Compression 390xp.

 

[lostone]

Ready for a squish band cut and all measured up.
View attachment 771272

On a phone looking at this and can't tell. What lathe is that?

 

[Yotaismygame]

On a phone looking at this and can't tell. What lathe is that?

Logan 210