Would you re-use this cylinder?

[Marty Lawrence]

Although I can see scratches above the intake & exhaust ports, I cannot feel with finger or nail, However I can feel below the ports. And there is some chipping below the intake

Would you re-use?

 

[209CrownKing]

Although I can see scratches above the intake & exhaust ports, I cannot feel with finger or nail, However I can feel below the ports. And there is some chipping below the intake

Would you re-use?

Is this a joke? If not I wouldn't personally. From the pics it looks like your cylinder is scored. If you can feel grooves in the cylinder that are indented then it's junk. Alot of time the cylinders will get what's called transfer. You can sand transfer out with aluminum oxide sandpaper or use muriatic acid (I don't recommend acid). Really only works on nikasil , chrome cylinders like what's found on most echos are too soft and the chrome will come off with the transfer. Hope this helps, good luck!

 

[NSEric]

There's too much damage under the intake port to make that cylinder savable, it's toast.
The transfer above the exhaust port would likely come off with some sand paper honing tho.

 

[pioneerguy600]

In the right hands that cylinder could be reworked to run and last a good long time but for the uninitiated /inexperienced cylinder porter it likely would not get the attention needed and then eat up a new piston.

 

[buzz sawyer]

Depends on how you want to run it. If only occasionally for light work, I'd clean it up. If you're planning to cut a lot of wood or doing this for a client, I would replace it. I've cleaned up much worse for a friend who only light cutting and couldn't afford a new P&C.
Whichever way you go, make sure there are no air leaks and the carb is set correctly, even a little rich. Probably use 32:1 fuel mix.

 

[ChillyB]

It would cost you only a piston and ring to find out. But as stated above if doing this for a living, and if this is a saw for which you don't have a backup, it could cost a lot more in time and reputation

 

[lone wolf]

Although I can see scratches above the intake & exhaust ports, I cannot feel with finger or nail, However I can feel below the ports. And there is some chipping below the intake

Would you re-use?

I wouldn't that looks like too much damage