husky

Figured id just drop a pic of my 2100cd project so far. Just threw a new piston in it tonight and it fired up right away. So far so good!

I just got a nearly new Husky 141 (41) (Poulan) for next to nothing. Saw is mint. However all of the lines were of course, destroyed into tiny pieces. I need some guidance on how the lines are run for supply to the carb and where the vent is located. I have looked in the illustrated parts...

Front of piston was all scarred up, rings fried, rear of piston and cyl fine. Almost seems the cyl wasn't straight? Definitely pointing forward. $150 down the drain.

Hello all, been searching for an answer, I have seen a number of possible solutions, just not much feedback afterwards to know what worked for others. Anyway, have a 2010 husqvarna 445. This saw probably has 4-5 hours run time on it, total. Starts easily, runs great for a cut or two, then bogs...

Includes: (1) Each 1/16, 7/64, 1/16, 1/8, 5/64, 9/64, 3/32, 5/32, 3/32, 11/64, 7/64, 3/16, 1/2, 3/8, 5/16, 1/4, 5/64, 7/32, 13/64" Features: Speed Tip Reduces Walking, Titanium Coating for Longer Life $25.00 Plus Shipping & Handling You, the buy pays shipping. Payment will be taken by PayPal or...

Brand New, Never Used, Not a Single Bit has been used! I'm a Milwaukee Tool kinda guy so yellow is not my brand. Has been sitting on the shelf in my shop for months. Need the space, want to get rid of it. Also posted locally on Craig's. Payment will be taken through PayPal or USPS Money Order...

I'm new to the site. Read alot of posts but just joined today to look for help. My problem is this, I got a 2011(?) 359. Just recently, it started being very hard to start, cold or hot, then it totally quit running period. I rebuilt the carb (Zama), and it would start but was very hard to get...

I have a Husqvarna 350, I am in need of a new piston and cylinder. I have read almost every recent thread about a 345-353 rebuild, 346xp swap, I don't know what to get for my little 350. I'd like to have the power of the 346xp, but would it be easier just to put a normal 350 AM cylinder and a...

Looking for parts for a Jon 630. Specifically a muffler, preferably modded. A full wrap handlebar and stock or aftermarket felling dogs. Or husky equivalent parts are fine too. Any line on these would be appreciated.

I recently purchased a husky 288xp for $200 with a 32inch bar the saw was ugly but it fired up and I was able to cut a little fire wood after grinding the chain and tightening few things up. but it just didn't seem to have the power, so I puchese a new cylinder and piston on e bay from little...

SO I have a little Husky 142 E series Saw I got new a few years ago... it was running ok but would not idle so I took it into the shop to get it cleaned up and tuned but when they took it apart they discovered the cylinder and Piston were all scored up and told me its gone as in, throw it away...

Hey guys new to the site but I've been stalking threads for years. That said I need help with a saw a bought from a member. It's a 2013 model 550xp. Only blows 110psi on compression gauge but starts and seems to cut well. For the first 10-15 minutes anyway. I was blocking firewood tonight...