394xp kill switch wire routing?

[david newbie]

I cant figure out how this wire gets up into the carb area where the with and terminal are? Seems like it should go through the hole near that yellow wire, but that doesn't get it up into the carb are Is there an opening in the carb floor area Im missing? Thanks for the use of your brain

 

[cscltd]

I think it goes in the same hole as carb adj screw access. The carb hole adjuster insert that goes in that hole has a little cut away for the wire to hold in place.

 

[Gord404]

bottom left hand corner of that rubber on it- did one last week.

 

[david newbie]

bottom left hand corner of that rubber on it- did one last week.

So, I probably would need that little square block that is for the idle adjustment? Will have to find on online

 

[Gord404]

well the 394 has a blue plastic piece that goes through the rubber after it is in place to adjust your idle- 395 is different

 

[huskihl]

The 394 tuning grommet is hard to find. 395 grommet works but you’ll need to slot your 394 idle screw so you can adjust idle speed.

The others are right. It goes in the grommet cutout in the lower left side of the square-ish casting hole

 

[david newbie]

The 394 tuning grommet is hard to find. 395 grommet works but you’ll need to slot your 394 idle screw so you can adjust idle speed.

The others are right. It goes in the grommet cutout in the lower left side of the square-ish casting hole

I just posted it in the trading post. Someone else will have to install grommet if they feel the need. Thanks