Steve NW WI
Unwanted Riff Raff.
95. It needs the oiler holes that the 41 lacks. Some machining would make it 041 compatible.Did anybody verify the bar mount? A095 or a041?
95. It needs the oiler holes that the 41 lacks. Some machining would make it 041 compatible.Did anybody verify the bar mount? A095 or a041?
I'll see if I can measure them tonight. They are either 4 or 5mm I think.
Ok, I'll check it out.95. It needs the oiler holes that the 41 lacks. Some machining would make it 041 compatible.
Drill bit and a tap and install one? I got a couple more out of the boxes and hung the bars and fueled them, they all start nice and easy.Good luck with the surgery.
From what I can tell these saws do not appear to have decompression technology to aid start up.
Drill bit and a tap and install one? I got a couple more out of the boxes and hung the bars and fueled them, they all start nice and easy.
Drill bit and a tap and install one? I got a couple more out of the boxes and hung the bars and fueled them, they all start nice and easy.
Good luck with the surgery.
From what I can tell these saws do not appear to have decompression technology to aid start up.
Hands down the Quaker's would, I'd rather run the quake any day over a MS250 the anti vibe on the Quake is much better.what do you think would last longer? 1 used CL MS260 or 4 quakers? about the same price.
The other orange saws in the garage are probably talking smack right about now, "There goes the Neighborhood!"SHOW OFF!
5mm x 10mm longAnybody know what size those little screws at the bottom of the muffler are? I lost mine somewhere.........
Enter your email address to join: