Sold Dolmar 7900

[shorthunter]

I have a Dolmar 7900 that I would like to sell. This is a worksaw, it has a few scratches but everything works as it should. The saw starts with just a few pulls, it idles well, it oils a 24" bar well and it has plenty of power in the cut.

I recently installed a 54mm NWP piston and cylinder kit with a 385xp piston ring (1 piece ring vs NWP two piece ring). It is blowing just over 170 pounds of compression on my craftsman gauge.

Asking $425, would entertain trade offers for the right MS-261(M-tronic)

 

[CR500]

Tempting lol


Good looking early 7900

Sent from my non internal combustion device.

 

[shorthunter]

I can box it up for you tomorrow. Could even send you a bar and chain if you needed one

 

[porsche965]

These are great saws from a power to weight ratio from a great seller.

 

[Ronaldo]

Most 7900's I see have a black top, never have seen a red one. Is this just an older model or European model?

 

[shorthunter]

The early 6400, 7300, 7900 saws had orange top covers

 

[Ronaldo]

The early 6400, 7300, 7900 saws had orange top covers

It looks to be in good condition, for being an older one.

 

[shorthunter]

Its not too bad, has a few dings and scratches

 

[Ronaldo]

They get way when a guy uses em, huh?

 

[shorthunter]

They get way when a guy uses em, huh?

Yep

 

[shorthunter]

Saw is SOLD

 

[sawjunky23]

Bout time somebaody bought that saw. A guy has only so much self control