Dolmar repair recommendations

[RedneckChainsawRepair]

6K made one 3/8LP picco 7T rim I had.


Stihl Picco 7T rim.....1.433 dia = 4.502 circumference
Reg. 3/8 7T rim 1.380 dia = 4.335 circumference

 

[pioneerguy600]

6K made one 3/8LP picco 7T rim I had.


Stihl Picco 7T rim.....1.433 dia = 4.502 circumference
Reg. 3/8 7T rim 1.380 dia = 4.335 circumference

Thanks for the precise measurements, I knew they were different but had not actually measured them. Will bookmark this for future references.

 

[RedneckChainsawRepair]

Thanks for the precise measurements, I knew they were different but had not actually measured them. Will bookmark this for future references.

I saved it years back and in a picco thread we had on this many years ago at my old website. I just use it like a file cabinet to save stuff.

 

[Mike Ray]

May I ask what you are mostly cutting with that setup,Mike? I cut more hardwood species more than softwood so that may be a reason I like .325 on 50 cc class saws, the 3/8" I have tried will drag the engine down below its powerband and often slips the clutch when the tree diameter comes close to 16", then the bigger saws come out.

i TRY TO CUT MOSTLY DEAD STUFF, PREFER DEAD LOCUST THAT DRIED OUT ENOUGH FOR THE BBARK TO HAVE FELL OFF (CLEANER) THEN OAK, HICKORY, ASH, MAPLE. i ALSO GO TO BIGGER SAW IN BIG WOOD, WITH MY 50 cc SAWS USUALLY 14" OR LESS.