Ethanol Free gas

[Jason Pitcher]

This was off a mower I was working on when I had a brief stint as a small engine mechanic. It was like a gel. Not sure if this was from pump gas or something else. Still I only use clear premium in all my small engines.

 

[Automan]

This was off a mower I was working on when I had a brief stint as a small engine mechanic. It was like a gel. Not sure if this was from pump gas or something else. Still I only use clear premium in all my small engines.

Premo in 2 strokes is mandatory for pre-ignition, leading up to detonation and more pre-ign. when running air cooled engines Balls Out.
Ethanol up to 15% is ok except for air moisture. It actually raises octane.(another story for that)

Miscibility of ethanol in water is infinite. (it is in solution) Just check the half full old vodka bottle.

Nearly same as for water in ethanol.

Air moisture is not just water in solution. Air has contaminates, and so does the water in the air.
Gasoline with eth. has limited solubility
So gasohol mix will separate what is not in solution.
This brings chemicals from the gasoline out(sulfur, calcium, mag, man) out of the gasoline as a precipitate.

White/yellow chalks found in carb.

cliff

 

[bwalker]

Premo in 2 strokes is mandatory for pre-ignition, leading up to detonation and more pre-ign. when running air cooled engines Balls Out.
Ethanol up to 15% is ok except for air moisture. It actually raises octane.(another story for that)

Miscibility of ethanol in water is infinite. (it is in solution) Just check the half full old vodka bottle.

Nearly same as for water in ethanol.

Air moisture is not just water in solution. Air has contaminates, and so does the water in the air.
Gasoline with eth. has limited solubility
So gasohol mix will separate what is not in solution.
This brings chemicals from the gasoline out(sulfur, calcium, mag, man) out of the gasoline as a precipitate.

White/yellow chalks found in carb.

cliff

Premium isn't mandatory in two stroke chainsaws. They have very low compression ratios.
The other thing is higher octane doesn't prevent pre ignition. It prevents detonation.

 

[Automan]

Premium isn't mandatory in two stroke chainsaws. They have very low compression ratios.
The other thing is higher octane doesn't prevent pre ignition. It prevents detonation.

No pissing match here, but deto leads to hot chamber leads to pre-ign.
Pre-ign. leads to deto also.

True, higher octane ******* deto. but, it also slows burn rate and heat rejection to chamber and spark plug, near TDC.

 

[bwalker]

No pissing match here, but deto leads to hot chamber leads to pre-ign.
Pre-ign. leads to deto also.

True, higher octane ******* deto. but, it also slows burn rate and heat rejection to chamber and spark plug, near TDC.

Typicaly no. Because the portion of the chamber where deto occurs is on the exhaust side at the outer edge where it's hottest. The center near the spark plug tends to run much cooler.
Pre ignition is usually caused by plug heat range, mettalic deposits, to much timing advance, or a combination of the those three factors.
Higher octane does not slow burn rate either. Slowing burn rate lowers octane as the faster you can burn the fuel air mixture the less chance you have for detonation to occur. The fastest burning gasolines are pro stock drag fuels, which also have some of the highest octane ratings.
No pissing match, just stating the facts.
Now, deto can lead to pre ignition if you have one or more of the three factors I mentioned above, butbit typicaly doesnt. Once pre ignition haopens you end up with a hole in the center of your piston almost instantly.
I have seen many pistons that failed from deto and several from pre ignition, but known have shown evidence of both phenomenon going on.

 

[Automan]

Typicaly no. Because the portion of the chamber where deto occurs is on the exhaust side at the outer edge where it's hottest. The center near the spark plug tends to run much cooler.
Pre ignition is usually caused by plug heat range, mettalic deposits, to much timing advance, or a combination of the those three factors.
Higher octane does not slow burn rate either. Slowing burn rate lowers octane as the faster you can burn the fuel air mixture the less chance you have for detonation to occur. The fastest burning gasolines are pro stock drag fuels, which also have some of the highest octane ratings.
No pissing match, just stating the facts.
Now, deto can lead to pre ignition if you have one or more of the three factors I mentioned above, butbit typicaly doesnt. Once pre ignition haopens you end up with a hole in the center of your piston almost instantly.
I have seen many pistons that failed from deto and several from pre ignition, but known have shown evidence of both phenomenon going on.

All true, except we are mainly speaking of 2 stroke engines.
No hot exhaust valves to deal with!
c